公司新聞
壓路機定期換液壓油方法要正確
來源：http://m.yinyudi.com/ 日期：2022-05-30
對于壓路機來說，液壓油是保持機器正常、高效作業的關鍵。所以，要想更好的發揮壓路機的性能優勢，就一定要做好其液壓油的定期更換工作，當然操作方法要正確才行。
For the road roller, hydraulic oil is the key to maintain the normal and efficient operation of the machine. Therefore, if you want to give better play to the performance advantages of the roller, you must do a good job in the regular replacement of its hydraulic oil. Of course, the operation method should be correct.
無論是工作時間多長，濟南壓路機出租廠家都建議液壓油每年至少更新一次，以防止油液變質污染液壓系統。換油之前應先起動發動機運轉，將液壓油暖熱以利于排放。
No matter how long the working hours are, Jinan roller rental manufacturers recommend that the hydraulic oil be updated at least once a year to prevent the oil from deteriorating and polluting the hydraulic system. Before oil change, start the engine to warm up the hydraulic oil for drainage.
應合理控制油的添加量。添加的油越多越好。為防止油加得過多，加注油時應采用少加次數的方法。加注一次后等待約5分鐘，觀察油尺上的油位，檢查油位是否在正常油位，如果不是，繼續少加一點，直到油位不低于下刻度線，也不高于上刻度線，剛好在正常油位。
The amount of oil added shall be reasonably controlled. The more oil you add, the better. In order to prevent excessive oil filling, the method of less oil filling times shall be adopted during oil filling. Wait for about 5 minutes after filling once, observe the oil level on the dipstick, and check whether the oil level is at the normal level. If not, continue to add a little less until the oil level is not lower than the lower scale mark, nor higher than the upper scale mark, and just at the normal level.
然后是更換機油。長期使用機油的粘度會逐漸降低，失去潤滑作用。如果不更換，會造成發動機零件的磨損。機油含有雜質，長期工作會造成氣缸拉缸。因此，要經常檢查，定期更換，并根據相應的標簽注意機油。滾筒發動機的正常運轉和使用壽命與機油息息相關，使用時應注意。
Then change the oil. After long-term use, the viscosity of the engine oil will gradually decrease and the lubricating effect will be lost. If not replaced, engine parts will be worn. The engine oil contains impurities. Long term operation will cause cylinder pulling. Therefore, it is necessary to check frequently, change regularly, and pay attention to the oil according to the corresponding label. The normal operation and service life of the cylinder engine are closely related to the engine oil, which should be paid attention to during use.
更換液壓油時，放油時先擰下排放螺塞放空油箱，再拆開系統中進排油路的較低油管接頭，排空回路中的油。拆下油箱蓋，用柴油清洗油箱內外及箱蓋、螺塞、管接頭等。清洗完畢，重新裝好油塞、管接頭及箱蓋，加滿新油。試車運轉，并操縱各液壓系統，檢查油位及是否滲漏，需要時可再加注適量的油。
When replacing the hydraulic oil, firstly unscrew the drain plug to drain the oil tank, and then disassemble the lower oil pipe joint of the oil inlet and outlet circuit in the system to drain the oil in the circuit. Remove the oil tank cover, and clean the inside and outside of the oil tank, as well as the cover, screw plug, pipe connector, etc. with diesel. After cleaning, reinstall the oil plug, pipe joint and tank cover, and fill with new oil. Test run, operate each hydraulic system, check the oil level and whether there is leakage, and refill an appropriate amount of oil when necessary.
壓路機運行前應做好準備工作，以減少設備運行過程中出現故障的概率，液體檢查，量應充足，不應有滲漏。此外，還需要檢查小輥相互連接的部分是否有松動現象。壓路機作業前，先檢查周邊施工環境，并提前清理周?chē)姓系K物的環境，方可正式作業壓路機作業。而且，操作人員要精通壓路機的操作方法，正確操作。調整小滾筒，使其處于良好的工作狀態。
Preparations shall be made before the operation of the roller to reduce the probability of failure during the operation of the equipment. The liquid inspection shall be sufficient without leakage. In addition, it is also necessary to check whether the connecting parts of the small rollers are loose. Before the operation of the roller, the surrounding construction environment shall be checked first, and the surrounding environment with obstacles shall be cleared in advance before the formal operation of the roller. Moreover, the operator shall be proficient in the operation method of the roller and operate correctly. Adjust the small roller to make it in good working condition.
因此不僅要及時的添加，還要定期的更換，所以壓路機液壓油添加也是有講究的，以上便是相關內容了，您可以關注我們網站m.yinyudi.com了解獲取更詳細的信息。
Therefore, it is not only necessary to add the hydraulic oil in time, but also to replace it regularly. Therefore, it is also important to add the hydraulic oil of the road roller. The above is the relevant content. You can pay attention to our website www.ycgjglcl Learn about. Com for more information.
公司地址：濟南市商河縣賈莊鎮民營經濟創業園
公司名稱:永誠廣建公路材料（山東）有限公司 
備案號：